Du måste acceptera vår privacy policy for att kunna skicka förfrågan.
Du måste acceptera vår privacy policy for att kunna skicka förfrågan.
Munters ML Plus-system skapar ett kontrollerat klimat i vägningskammaren.
PolyPeptide-koncernen arbetar med tillverkning och utveckling av peptider. Företaget hanterar peptidproduktion från småskaliga (multi-10 mg) icke-GMP partier till multi-10 kg (och större) GMP-tillverkningsbehov. Koncernen har mer än 50 års global erfarenhet inom området.
Several Munters dehumidifiers have been creating optimal climate conditions in various applications in the Swedish facility for many years.
A Munters ML Plus system was recently installed in a small Quality Department weighing room to fulfil FDA requirements.
Strictly controlled conditions, identical to the production climate, were required: 20°C/25% RH during the entire year.
Pleased with existing Munters installations, PolyPeptide asked Munters to design a unit that could meet FDA requirements. A ML Plus 420 was configurated. This elegant solution combined modules for pre and post air-treatment, which was very much appreciated by PolyPeptide.
Besides the basic dehumidification module, the unit consists of modules for pre-heating and cooling, post-cooling and humidification.
The small footprint of the unit was also helpful since the system was installed in the attic above the weighing room along with some air handling units.
The systems run as an open system for hygienic purposes. On warm humid days the dehumidification process secures the necessary low relative humidity, while on cold winter days the humidifier prevents static electricity that would create problems during the accuracy-dependent, demanding weighing procedure.
Worker safety is also improved, preventing preparation particles or samples to infiltrate air inhaled by laboratory technicians.
ML Plus - built with standard modules
The ML Plus concept is a compact standardised stand-alone dehumidification system with incorporated temperature and humidity control.
The ML Plus-system can be configured with a supply fan, humidifier, pre and post-coolers and heaters according to requirements.
The ML Plus system is built up in elements, assembled and tested at our factory - ready for immediate start-up on site.
Small footprint - easy installation
Standardisation has made it possible to minimise footprint measurements. This enables a simple integration of ML Plus into most moisture-sensitive production processes.
ML Plus can be delivered with a dehumidification capacity up to 17.5 kg/h and airflows up to 5,500 m³/h. The system is quick and easy to connect to existing pipes and ducts.
E-postadressen är ogiltig
Oops, någonting gick fel! Försök igen om en stund.
Glömt lösenord?
E-postadressen är ogiltig
Oops, någonting gick fel! Försök igen om en stund.
Check your email within a couple of minutes to reset your password, if you can’t see any incoming messages try to check into your spam folder!