메시지 전송 시, 오류가 발생하였습니다. 재시도하십시오
메시지 전송 시, 오류가 발생하였습니다. 재시도하십시오
문의 하십시오
사업 영역
로그인
The Riser Deck Distributor is a deck type distributor where orifices are located on the base/deck of the distributor. Gas risers located between the orifices propagate liquid cross-flow, thereby enhancing distribution quality.
This style of distributor is generally supplied in multi-piece construction and all joints are sealed with gaskets. Attachment is by clamping to a ledge/support ring that is welded to the column wall. This distributor can be provided with anti-migration bars in the risers to eliminate the requirement for a bed limiter.
Redistributor risers are capped to prevent bypassing of liquid through risers from liquid raining down from the packed bed above.
Selection criteria*:
• Column diameter > 600 mm (24 inches)
• Maximum Turndown ratio 2:1
• Liquid rates > 5 m3/m2hr (2.0 GPM/ft2)
• Low fouling
*Selection criteria guidelines provided are typical but not limiting. Under certain conditions, special design provisions can be made for accommodating varied hydraulic and mechanical requirements.
아이디 또는 비밀번호를 다시 확인하세요
오류. 나중에 다시 시도하십시오
비밀번호를 잊으셨나요?
아이디 또는 비밀번호를 다시 확인하세요
오류. 나중에 다시 시도하십시오
Check your email within a couple of minutes to reset your password, if you can’t see any incoming messages try to check into your spam folder!