エラーが発生しました。後でもう一度試して下さい。

ご質問はお問い合わせください

お困りですか?

会員登録はこちら
クッキーポリシーを許可するにはこちらを選択してください。 クッキーポリシー

ユーザーIDが正しくありません。

エラーが発生しました。後ほどもう一度お試しください。

ユーザーIDが正しくありません。

エラーが発生しました。後ほどもう一度お試しください。

AirT-High-Temp-CS0086-Unit.jpg

Recovering Heat From a Dehumidification Process

A major international pharmaceutical company manufactures prescription medications and specializes in cancer care products. Their production process is sensitive to moisture because in several phases, the drugs are in hydroscopic form, meaning they absorb moisture. Exposure to moisture can lead to problems such as difficulty in forming drugs into tablets.

To maintain proper humidity levels in its manufacturing environment, the company installed an air handling unit several years ago with a desiccant wheel for dehumidification. When the desiccant becomes saturated with moisture, hot air is run through it to regenerate the medium.

The system worked well for several years, but Munters recognized an opportunity to make the system more efficient. A Munters Z-Duct® air-to-air heat exchanger was placed downstream of the
desiccant wheel to recover heat from the discharge during the regeneration cycle. The captured heat is then used to heat outside air coming into the reactivation side of the dehumidifier. This decreases the amount of steam required for heating the
regeneration air which reduced the fuel needed at the plant’s gas-fired boiler. As a result, the heat exchanger paid for itself shortly after the unit went into operation.

情報

  • Reduced building heat energy bills
  • Reduced emissions
  • Increased overall system efficiency